Mazda 0000-8F-N02B Manuel du propriétaire télécharger pdf (Page 24)

4280159 Rev. A 10/10

SERVICE PART NUMBER LIST

Part Number Description

0000-8F-H03 Hood Safety Switch Kit Service Part

0000-8F-H05A Mazda Immobilizer Interface Service Part

0000-8F-M21 Mazda CX-7/CX-9 DNA Card Software Service Part

0000-8F-N18A Mazda CX-9 Remote Start Wire Harness Service Part

0000-8F-Z01 Remote Start Control Module Service Part

0000-8F-Z02 Mazda 1-Button Remote Start Transmitter Service Part

0000-8F-Z03 Emergency Override/Programming Button Service Part

0000-8F-Z10 Dipole Antenna Service Part

0000-8F-Z12 Underhood Warning Label Service Part

PowerCode®, IT-s®, Real Panic Sound® and Progressive Find® are registered trademarks of Code Systems, Inc.

The hood safety switch will need to be adjusted to shut down the vehicle when the engine hood is raised to the full upright

position.

1. Raise and prop the vehicle’s engine hood.

2. The hood switch cylinder should be bend away from the hood to approximately 15 degrees above parallel with the

ground. (FIGURE CCC)

3. After the adjustment has been made, verify that remote engine start does not engage when the vehicle’s engine

hood is open.

4. If the remote engine start engages with the engine hood in the full upright position, the switch will need to be bent closer

to the engine hood.

NOTE: IT IS VERY IMPORTANT TO VERIFY THAT THE HOOD

SAFETY SWITCH PREVENTS THE REMOTE ENGINE START

SYSTEM FROM ENGAGING WHEN THE VEHICLE’S ENGINE

HOOD IS IN THE FULL UPRIGHT POSITION

FIGURE CCC

HOOD SAFETY SWITCH ADJUSTMENT

1 2 ... 19 20 21 22 23 24 25 26

Pas de commentaire

Mazda 0000-8F-N02B Manuel du propriétaire Page 24