Mazda LF Manuel de service télécharger pdf (Page 44)

ENGINE

B–27

15. Install the exhaust camshaft sprocket.

Note

• Do not tighten the bolt for the camshaft

sprocket during this step. First confirm the

valve timing, then tighten the bolt.

16. Install the SST to the camshaft as shown.

Europe

Except Europe

17. Remove the M6 x 1.0 bolt from the engine front cover to apply tension to the timing chain.

18. Turn the crankshaft clockwise the crankshaft is in the No.1 cylinder TDC position.

19. Hold the exhaust camshaft using a suitable

wrench on the cast hexagon as shown.

20. Tighten the exhaust camshaft sprocket lock bolt

Tightening torque

69—75 N·m {7.10—7.6 kgf·m,

50.9—55.3 ft·lbf}

21. Remove the SST from the camshaft.

22. Remove the SST from the block lower blind plug.

23. Rotate the crankshaft clockwise two turns until

the TDC position.

• If not aligned, loosen the crankshaft pulley

lock bolt and repeat from Step 14.

24. Apply silicone sealant to the engine front cover upper blind plug.

AME2212W007

AME2212W010

AME2212W011

AME2212W006

1731-1E-02C.book 27 ページ２００２年４月２６日金曜日午前１０時３０分

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 69 70

Pas de commentaire

Mazda LF Manuel de service Page 44