1 GENUINE CAR-NAVIGATION UNIT INSTALLATION INSTRUCTIONS Thank you for purchasing a genuine Mazda accessory. Before removal and installation, be sure
10 6. Touch the screen. 7. Touch “Setting”. 8. Touch the location shown in the figure. 9. Touch “Reset factory setting”.
11 11. Touch “Yes”. 12. Setting is finished when “Welcome” screen appears. 13. Switch the ignition off.
Date , , VINApproved Checked Person in charge INSTALLATION INSPECTION SHEET MAZDA6 Car-navigation unit GJY1 79 EZX
2 ▼ PARTS LIST • GJY1 79 EZX (US/CANADA), GJY2 79 EZX (MEXICO) Part Part name Qty. Part Part name Qty. Part Part name Qty. Car-navigation uni
3 Negative battery cable disconnection 1. Set the selector lever to P range. (AT vehicles only) 2. Disconnect the negative battery cab
4 2. Insert two pieces of wire or two bands (use hard acrylic bands) into the locations shown in the figure and secure both ends. (Figure shows bands
5 2. Install the wiring harness clips(2). 3. Press the clips (4 locations) shown in the figure and install the car-navigation unit
6 GPS CONNECTOR INSTALLATION(US/CANADA only) Glove compartment removal 1. Push the glove compartment in the direction of the arrow (1) and hooks A. 2
7 1. Connect the negative battery cable and perform an operation check by referring to the owner’s manual applicable to the vehicle. 2. If there
8 6. After switching to the Vehicle and Navi Signal Check screen, touch “ “on the screen to switch the display screen to “NAVI GPS ANT”. Verify th
9 Reset procedure 1. Touch "No”. 2. Touch “Join Map Share”. 3. Touch “Continue”. 4. Touch “Yes”. 5. Touch “I agree”
Commentaires sur ces manuels