WL-C Engine Control System
• The PCM has two connectors with 154 pins in total.
BT-50_01041
• Similar to other current modules the PCM now allows to carry out the following
programming functions by means of M-MDS:
– Programmable module installation (to replace PCM)
– Module reprogramming (to update software calibration)
– Programmable parameters (to input injector correction factors)
– As-build data (to update As-build data)
– Data reset (PCM and MAF sensor)
– MAF learning (to adapt MAF sensor condition to PCM)
NOTE: For replacement of the PCM certain procedures have to be followed (refer to the
chapter ‘Maintenance and Repair’).
A/C Cut-Off Control
• Under the following engine operating conditions the PCM turns the A/C relay off to
improve driveability:
– For a certain time when the accelerator-opening angle is 87.5 % or more.
– Permanently when ECT is above 113 °C until temperature falls below 110 °C.
Service Training BT-50 01-49
Commentaires sur ces manuels