Mazda 0000-8F-N02B Manuel du propriétaire télécharger pdf (Page 13)

4280159 Rev. A 10/10

Ribbon Cable

Non-conductor

side

Conductor

side

IMMOBILIZER INTERFACE RIBBON CABLE MOUNTING

1. Route the immobilizer interface ribbon cable to the ignition switch.

2. Following the instructions on the supplied adhesive primer stick,

apply a thin coating to the outer surface of the immobilizer antenna

coil (black plastic ring around ignition switch) and to the ribbon

cable.

CAUTION: Avoid primer contact to visible areas of the immobi-

lizer antenna coil and ignition switch to prevent possible discol-

oration of any plastic components.

3. Remove the backing from one side of the supplied 2-way tape and

apply tape around the immobilizer antenna coil (black plastic ring

around ignition switch) keeping the tape off of the rounded part of

the ignition switch face by trimming excess 2-way tape, if neces-

sary. (FIGURE EE & FF)

4. Remove the remaining backing on the 2-way tape and position the

2-conductor ribbon cable around the immobilizer antenna coil, with

the gray or black non-conductor side facing away from the ignition

key opening. (FIGURE GG, HH & JJ)

5. Separate approximately 100 mm of the twisted red or black ribbon

cable and create a second loop around the immobilizer antenna

coil directly in front (toward the ignition key opening) of the first

loop. (FIGURE GG, II & JJ)

6. Using (1) supplied, short wire tie, secure the antenna coil.

(FIGURE GG, II & JJ)

FIGURE EE

Smart-Key

CAUTION: THIS IS A CRITICAL STEP THAT MUST BE FOLLOWED

PRECISELY FOR PROPER REMOTE START OPERATION.

FIGURE FF

Retractable Key

FIGURE GG

Smart-Key

Retractable Key

FIGURE HH

First Loop

Second Loop

Wire Tie

FIGURE II

Retractable Key

Wire Tie

First Loop

Second Loop

FIGURE JJ

Retractable Key

First Loop

Second Loop

Wire Tie

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Mazda 0000-8F-N02B Manuel du propriétaire Page 13

Commentaires sur ces manuels