Mazda 2006 RX-8 Spécifications télécharger pdf (Page 291)

Black plate (291,1)

NOTE

If the “FL22” mark is shown on or near

the cooling system cap, use FL22 type

engine coolant. If engine coolant other

than FL22 type is used, the engine

coolant must be replaced earlier than

the specified repla cement interval

indicated in the scheduled maintenance

(page 8-3).

Except FL22 type

For mixture percentage:

Protection

Volume

Antifreeze

solution

Demineralized

water

Above

_

16°C

(3°F)

35% 65%

Above

_

26°C

(

_

15°F)

45% 55%

Above

_

40°C

(

_

40°F)

55% 45%

FL22 type

FL22 type engine coolant concentration is

factory adjusted. Use the product as it is

without diluting it.

To change coolant

WARNING

Removing the Cooling System Cap:

Removing the cooling system cap

while the engine is running or hot is

dangerous. This might lead to cooling

system and engine damage and could

result in serious injury from escaping

hot coolant or steam. Turn off the

engine and wait until it's cool. Even

then, be very careful when removing

the cap. Wrap a thick cloth around the

cap and slowly turn it

counterclockwise to the first stop.

Step back while the pressure escapes .

When you're sure all the pressure is

gone, press down on the cap ― still

using a cloth ― turn the cap, and

remove it.

1. Remove the cooling system cap.

2. Only when the engine is cool, loosen

the radiator drain plug and drain the

coolant into a suitable container.

Properly dispose of the used coolant.

3. With the drain plug loose but not fully

removed, flush out the system with

running water.

Tighten Loosen

Loosen

Tighten

Maintenance and Care

Owner Maintenance

8-17

RX-8_8U58-EA-05J_Edition1 Page291

Thursday, August 25 2005 4:59 PM

Form No.8U58-EA-05J

1 2 ... 286 287 288 289 290 291 292 293 294 295 296 ... 433 434

Commentaires sur ces manuels

Pas de commentaire