Mazda LF Manuel de service télécharger pdf (Page 63)

B–46

ENGINE

4. Hold the crankshaft pully using the SST.

5. Tighten the crankshaft pulley lock bolt in the

following two steps.

(1) Tighten to 96—104 N·m {9.8—10.6 kgf·m,

70.9—76.7 ft·lbf}

(2) Tighten 87°

°°

°—93°

°°

° .

6. Remove the M6 x 1.0 bolt.

7. Remove the SST from the camshaft.

8. Remove the SST from the block lower blind plug.

9. Rotate the crankshaft clockwise two turns until

the TDC position.

• If not aligned, loosen the crankshaft pulley

lock bolt and repeat from Step 1.

10. Install the cylinder block lower blind plug.

Tightening torque: 20 N·m {2.0 kgf·m, 14.8 ft·lbf}

Cylinder Head Cover Aassembly Note

1. Apply silicone sealant to the mating faces as

shown.

Caution

•

••

• Install the cylinder head cover within 10

minutes of applying the silicone sealant.

Dot diameter: 4.0—6.0 mm {0.16—0.23 in}

2. Install the cylinder head cover with a new gasket.

3. Tighten the bolts in the order shown.

Tightening torque: 8.0 —12 N·m {81.6—122.3

kgf·cm, 70.9—106.2 in·lbf}

End Of Sie

AME2224E015

AME2224E335

AME2224E336

1731-1E-02C.book 46 ページ２００２年４月２６日金曜日午前１０時３０分

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 69 70

Pas de commentaire

Mazda LF Manuel de service Page 63